| *
C -
Cause; R - Remedy * |
| 1.
No washing water gets sprayed |
| |
C: |
The
water is not filled in the unit's internal water tank.
|
| |
R: |
Wait
about one minute. |
|
| |
C: |
Clogged
nozzle. |
| |
R: |
Clean
the nozzle. |
|
| |
C: |
Timed
operation stopped after one minute continuous use. |
| |
R: |
Press
the desired washing switch once again. |
|
| |
C: |
The
shutoff valve is closed. |
| |
R: |
Turn
on the shutoff valve to open. |
|
| |
C: |
Freezing
inside the main unit or the water supply pipe. |
| |
R: |
Raise
the room temperature. |
| |
|
Caution:
Operating FreshWash while parts are frozen will cause a malfunction. |
|
| 2.
Washing water is not warm |
| |
C: |
The
water temperature switch is set to Low. |
| |
R: |
Set
the water temperature to Hi; it will take about ten minutes to reach
HI. |
|
| |
C: |
Continuous
operation has depleted the supply of warm water. |
| |
R: |
Wait
about ten minutes. |
|
| 3.
Washing water pressure is weak |
| |
C: |
The
water pressure level is set to LO. |
| |
R: |
Set
the Water Pressure to HI. |
|
| |
C: |
The
strainer is clogged. |
| |
R: |
Clean
the strainer of the branching valve. |
|
| 4.
Seat is not warm |
| |
C: |
The
seat temperature is set to LO. |
| |
R: |
Set
the seat warmth to HI; it will take about twenty minutes to reach
HI. |
|
| 5.
Drying air is not warm |
| |
C: |
The
dry temperature is set to LO. |
| |
R: |
Set
the Dry temperature to HI. |
|
| 6.
The unit doesn't work |
| |
C: |
On/
OFF light is off. |
| |
R: |
Make
sure the power supply cord is connected properly.
Turn
on the unit by pressing ON/ OFF switch.
Check
the ON/ OFF light.
|
|
| |
C: |
The
seat is not aligned properly to the toilet bowl. |
| |
R: |
Align
the seat so that the sensor switch can work. |
|
| 7.
Water leaks |
| |
C: |
No
rubber/ plastic washer used at the connection. |
| |
R: |
Unfasten
the connections.
Insert
a proper washer.
Apply
TEFLON tape on the bolt thread area.
Connect
and tighten.
|
|
| |
C: |
No
TEFLON tape was used. |
| |
R: |
Unfasten
the connections.
Insert
a proper washer.
Apply
TEFLON tape on the bolt thread area.
Connect
and tighten.
|
| |
|
|
| |
|
|
| |
|
 |
Search
a Product
